Ⅰ 電子電工專業的英語高手救命呀:求翻譯
[Abstract] the subject of a design microcomputer regional warning system executing agencies -- sound and light alarm circuit. GB, the fire alarm system for the regional fire alarm and fault alarm, with light, and audio alarm circuit must send two different signals to show distinction. In response to this request, the circuit design of the audio alarm circuit using a loudspeaker. in the event of fire or failure of the issued under different acoustic signals, while bond with silencers. Alarm, Based on the single-chip microcomputer control regional warning system sound and light alarm circuit receiving MCU Controller of alarm signals, final warning signals using optical signal light and loudspeaker signal is displayed in the form of complete alarm function. Design corresponding oscillation circuit different frequency pulse signals, and through logic gate circuit assembly function make loudspeakers issued the warning at different frequency signal. D flip-flop used as a system reset, the report played a. function. This paper will function circuit design requirements, The circuit design and circuit analysis of the various parts of the circuit lap and debugging of the topics on the content, finally come to some conclusions.
Ⅱ 電子工程 英語
電子工程是面向電子領域的工程學。是研究電路與系統、通信、電磁場與微波技術以及數字信號處理等領域的一門工程學。對英語要求不高。
Ⅲ 電子工程專業科目英文名稱及縮寫
電路分析：Circuit
Analysis
模擬電路：Analog
Circuit
數字電路：Digital
Circuit
高頻電路：
High
Frequency
Circuit
信號與系統：Signal
and
System
數字信號處理：Digital
Signal
Processing
單片機：Single
Chip
Microcomputer
（MCU)
通信原理:COMMUNICATION
PRINCIPLE
感測器:Sensor
微機原理：MICROCOMPUTER
PRINCIPLE
匯編語言：Assembly
Language
C語言：language
C
電磁場理論：electromagnetic
field
theory
電工學：
Electrotechnics
protel
Ⅳ 求高手翻譯（關於電氣專業英語的）
1 Power transformer USES a step-down transformer, the power grid voltage 220 V transform into need ac voltage. The ac voltage after rectification, can obtain electronic equipment need dc voltage.
2The design of the rectifier circuit big filter capacitance, so the power of the instantaneous large current power supply features, little noise and reaction speed, output ripple small.
3The filter circuit capactance filtering circuit, will the pulsation of the rectifier circuit output filter out most of the ingredients from a smooth direct current. This circuit adopts the 3300 u F / 100 V large capacitance C3, C4 output voltage more smooth, the power supply characteristics moment, suitable for take perceptual load
4By LM317 output voltage circuit is power, LM337 output negative supply. LM317 and LM337 are used internal thermal overload, contains over current protection, hot off and safety working area compensation of perfect protection circuit, makes the power supply can save the fuse, and so easy loss device.
Regulating circuit: to meet the needs of the different application situation and the voltage is set to can be adjusted. Output voltage calculation Uo = 1.25 by (1 + Rf/R), can choose precision resistor adjustable resistance, guarantee the precise output voltage can be adjusted.
5The protection circuit for linear power supply heat bigger, so the power to add enough radiator. Due to the high performance integrated circuits, which can simplify the circuit structure, highlight the power transformation of the key part of the problem. Through the commissioning and testing, circuit performance is good. The power not only can be used alone, also can be in other electronic equipment used in voltage or current stabilization source use
Keywords: dc power rectifier circuit voltage filter circuit circuit protection circuit
Ⅳ 電路施工圖用英文怎麼講專業的
construction plans 施工平面圖
electric circuit diagram 電路圖
Ⅵ 電氣工程專業英語翻譯問題
1，當電子電路中的元器件特性遵循一般的伏安特性時，使用一般方式分析是一種工程師行業必要的練習。
2，線繞式
3，然而，這個分析任務是通過預知設計中存在的電路作用，這種作用決定於相互連接的元器件輸入特性
4，這個特徵等式建立在可測的電磁能量傳遞作用被忽略的基礎上。工業工程師規定：對比電磁干擾的波長，器件是極其微小的。這個被直接用在民用航空管理的方法這篇文章上被進一步發展。
Ⅶ 英語高手幫我翻譯一下，關於電路的。
翻譯質量可保證，不過太長了，加點分吧？
1 Introction
1.引言
THE USE of conventional, unsymmetrical amplifier circuits in biomedical engineering is very limited, because of their inadequacy in suppressing power-line interference.常規的不對稱放大器電路在生物醫學工程中的使用是有限的，因為它們在抑制電力線路的干擾上存在不足之處。 Because one of the patient electrodes is directly connected to the amplifier
signal ground and the other is a high impedance point, the interference
current flows only through the grounded electrode. 因為病人的電極中有一個直接連接到放大器信號接地，另一個是高阻抗點，所以干擾電流只流過被接地的電極。The grounded electrode impedance voltage drop is amplified and leads to circuit saturation or masking of the useful biopotential
signal. 該接地電極阻抗的電壓降被放大，並導致電路飽和，或者對有用生物電位信號的掩蔽。
Many biosignal acquisition devices could benefit from the use of only two electrodes. 很多生物信號採集裝置可以通過僅採用兩個電極而得到好處。Electrocardiogram monitoring in intensive care wards, ambulatory monitors, defibrillators etc.
are among the most common examples. 在重症監護病房中的心電圖監控、門診監測器、除顫器等是最常見的例子。
The most widely used technique for biosignal amplification is based on an instrumentation amplifier first-stage design, because of its ability to suppress the common mode interference
(NEUMAN, 1998). 最廣泛使用的生物信號放大技術是基於一種儀表放大器的一級設計，因為它能抑制共模干擾（Neuman，1998）In two－electrode instrumentation, the
amplifier inputs must have a differential impedance that is as high as possible to avoid signal attenuation. 在雙電極儀器應用中，放大器的輸入必須有盡可能高的差分阻抗，以避免信號衰減。On the other hand, the amplifier should have reasonably low common mode impedance, to create a path for the common mode interference
currents without significant voltage drop, keeping both inputs in their specified operating voltage range. 另一方面，放大器的共模阻抗應該合理地低，以便為共模干擾電流創造一個通路而不致有明顯的電壓降，從而將兩個輸入都保持在它們規定的工作電壓范圍內。
THAKOR and WEBSTER (1980) introced a bootstrapped input stage. However, it has an inctive common mode input impedance, resulting in a very poor common mode
input current range, especially for higher frequencies. Thakor和Webster（1980）引入了一個自舉（bootstapped）輸入級，產生了很差的輸入共模電流范圍（特別是在較高的頻率下）
A circuit for a two-electrode, non-differential amplifier was developed (DOBREV, 2002), the performance of which isquasi-equivalent to the differential amplifier described by DOBREV and DASKALOV (2002). Dobrev於2002年開發了一種用於雙電極、無差動放大器的電路，其性能准-等效於Dobrev和Daskalov（2002）所描述的差分放大器。
Because the body as signal
source is floating and, in addition, the modern biopotential amplifiers are isolated, it is possible to drive actively one of the electrodes to the circuit common potential and thus to
balance the flowing interference currents. 因為作為信號源的人體是浮動的，而且現代的生物電位放大器是隔離的，所以有可能主動地將電極中的一個激勵到電路的公共電位，並因此來平衡流過的干擾電流。
Now, a very simple, low-cost circuit of a two-electrode nondifferential
amplifier is suggested, where the interference current balancing is achieved by one operational amplifier
(OA) and two parallel RC networks.現在人們提出了一種很簡單而又廉價的雙電極、無差動放大器的電路，其中，干擾電流的平衡是靠一個運算放大器（OA）和兩個並聯的RC（阻容）網路實現的。
Ⅷ 電氣工程專業英語翻譯
在電路中，一個環是一個封閉的路徑包含電路元件。探索周圍的環電壓與電壓表很快表明，有一個法律管轄他們。考慮，例如，循環顯示順時針箭頭圖1-7a.there元素，因而有電壓，是與此相關的循環。假設我們把這些volatges城，是作者和東方的極性，都在同樣的意義：+ to-in順時針方向。見圖1-7a.tomeasure這些volatges，我們那兒的電壓表連接在fig.1-7b。注意極性標記的電壓表匹配的+和-名稱標記的變數，從而vaeiable價值觀是美國機械工程師學會為電壓表的讀數。當我們獲得的電壓表讀數，我們發現，U + U 2 + = 0上
Ⅸ 急急急！！！請英語高手翻譯：電路電工類．
With a control switch for electrical outlets, including: a socket body, for one of its top surface of one Aoru respectively, from the jack and a Snap box, and take power jack, a two-metal Next pole; a control switch, Snap in the Snap box and positioning, their input at the bottom of the two films and two respectively to a conctive film with a link from the top of the actuator switch so that the power of its two Output-output or cut off, from the jack, take two to obtain a power, through the control switch the switch, thereby control the power supply connector broken / Qualcomm.
Ⅹ 電氣工程專業英語 翻譯
接下來，假設所有的電流變數的方向是由節點流出而非流入，如圖1-5c所示。相應的，如圖1-5，為了測量出三個電流值，我們接了電流表。注意靠近節點的那端接三個電流表的正極，讀數表明三值之和為0.
因此我們能夠證明從節點流出的電流量和為0，事實上如果我們已經知道i1=i'1，i2=i'2.i3=-i'3，我們可以直接由等式1-1a推出等式1-1b，過程如下：（這個不寫了）
最後，假設兩個電流變數的方向是流入節點，一個為流出如圖1-5e所示。通過處理電流的讀數我們發現1-1c公式
因此我們可以證實流進節點的兩個電流值等於流出節點的電流值。再者，等式1--1c可有1-1a推出來，當得知i3=-i'3，過程如下，（這個不寫了）
或者我們可以通過1-1b等式，推出等式1-1c，過程如下：（這個不寫了）
1-5節點電流的基本特性
德國物理學家基爾霍夫首次發現了這一定律，電路中每個節點電流都要遵從這一定律，我們稱之為基爾霍夫定律。它可以用三種方式來表達，基於電流的方向。